INSTALLATION
Removal / installation · Vehicles built from Aug 2013
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. INSTALL REAR NO. 2 SEAT ASSEMBLY LH |
Fold the seat cushion.
Attach the rear side seat band and fix the seat cushion in place.
Place the rear No. 2 seat assembly in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
Temporarily install the nut.
Detach the rear side seat band and lower the seat cushion.
Temporarily install the 3 bolts.
Tighten the 3 bolts.
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Attach the 2 claws to close the cover.

Attach the 2 claws to close the cover.

Fold the seat cushion.
Attach the rear side seat band and fix the seat cushion in place.
Tighten the nut.
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Detach the rear side seat band and lower the seat cushion.
| 2. INSTALL REAR SEAT SIDE COVER LH |
Attach the 4 claws to install the cover.

