2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT FUEL PUMP
  1. Inspect the resistance of the fuel pump.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω

      If the result is not as specified, replace the fuel pump.

  1. A223267E01
    Inspect the operation of the fuel pump.

    1. Connect the positive (+) lead of the battery to terminal 1 of the connector and the negative (-) lead to terminal 2. Check that the fuel pump operates.

      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Pump)
      If the result is not as specified, replace the fuel pump.

      NOTICE:
      1. These tests must be performed within 10 seconds to prevent the coil from burning out.
      1. Keep the fuel pump as far away from the battery as possible.
      1. Always turn the voltage on and off on the battery side, not the fuel pump side.

← DISASSEMBLY (from Aug 2014)REASSEMBLY (Aug 2013 – Jul 2014) →