2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


NOTICE:
A223126
Do not disconnect the hoses indicated in the illustration.


1. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A223146
    Disconnect the fuel sender gauge assembly connector.

  1. A329765E01
    Press down on the fuel sender gauge assembly claw labeled A. Then slide the fuel sender gauge assembly upward to remove it.
    Text in Illustration 
    V100135
    Press down
    V100136
    Slide


2. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

  1. A223248
    Using a screwdriver, detach the 3 claws from the claw holes and pull out the fuel suction plate.

    NOTICE:
    Do not damage the No. 1 fuel sub-tank.


3. REMOVE FUEL PUMP HARNESS

  1. A223249
    Disconnect the fuel pump harness connector from the fuel suction plate.

  1. A223250
    Disconnect the fuel pump harness connector from the fuel pump.


4. DISCONNECT JET PUMP

  1. A152629E01
    Using a screwdriver, disconnect the jet pump from the No. 1 fuel sub-tank.
    Text in Illustration 
    *1
    Jet Pump


5. REMOVE FUEL PUMP

  1. A223251
    Using a screwdriver, detach the 2 claws from the claw holes and disconnect the fuel pump from the fuel suction plate.

    NOTICE:
    Be careful not to damage the O-ring surface.

  1. Remove the O-ring.

  1. Remove the fuel pump spacer.

← DISASSEMBLY (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →