INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT FUEL HEATER ASSEMBLY (w/ Fuel Heater) |
Measure the resistance according to the value(s) in the table below.

Measure the resistance between terminal 2 and the heater body.
Apply a vacuum of 29 to 40 kPa (218 to 300 mmHg, 8.56 to 11.8 in.Hg) or higher to the vacuum switch port.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
2 - Heater body
20°C (68°F)
0.5 to 2.0 Ω
If the result is not as specified, replace the fuel heater assembly.Text in Illustration *1
Heater Body
| INSPECT FUEL FILTER CAP ASSEMBLY (w/ Clogging Switch) |
Inspect the clogging switch.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
Below 1 Ω
