2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT NO. 2 FOLD SEAT SWITCH ASSEMBLY (for Rear LH)

  1. B239070E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (RTRN(L)) - 7 (E)
    RETURN LH switch pressed
    Below 1 Ω
    8 (FOLD(L)) - 7 (E)
    FOLD LH switch pressed
    1 (RTRN(R)) - 7 (E)
    RETURN RH switch pressed
    6 (FOLD(R)) - 7 (E)
    FOLD RH switch pressed

    If the result is not as specified, replace the No. 2 fold seat switch assembly.
    Text in Illustration 
    *1
    RETURN LH Switch
    *2
    FOLD LH Switch
    *3
    RETURN RH Switch
    *4
    FOLD RH Switch
    *a
    Component without harness connected
    (No. 2 Fold Seat Switch Assembly)

  1. B239072E01
    Apply battery voltage to the switch connector and check that the fold seat switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 5 (+B)
    Battery negative (-) → 7 (E)
    Illumination illuminates

    If the result is not as specified, replace the No. 2 fold seat switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 2 Fold Seat Switch Assembly)

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →