ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR |
Inspect the power source voltage.
Disconnect the manifold absolute pressure sensor connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
C83-3 (VC) - C83-1 (E)
Ignition switch ON
4.75 to 5.25 V
If the result is not as specified, inspect the wire harness or ECM (Click here).Text in Illustration *a
Front view of wire harness connector
(to Manifold Absolute Pressure Sensor)
Connect the manifold absolute pressure sensor connector.
Check the power supply.
Turn the ignition switch to ON.
Disconnect the vacuum hose from the manifold absolute pressure sensor.
Using SST, measure the voltage according to the value(s) in the table below.

- SST
- 09992-00242
- Standard Voltage:
Tester Connection
Condition
Specified Condition
C102-2 (PIM) - C102-9 (E2)
60 kPa (0.61 kgf/cm2, 8.7 psi)
0.4 to 0.6 V
87 kPa (0.89 kgf/cm2, 12.6 psi)
1.1 to 1.3 V
Text in Illustration *a
Component with harness connected
(ECM)
- HINT:
- The values in the "Condition" column are gauge pressures.
