2013-2015 Land Cruiser Prado · Service Manual Suspension

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT REAR HEIGHT CONTROL SENSOR

  1. Check the rear height control sensor.

    C214173E02

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Height Control Sensor)
    *b
    Min. Low
    *c
    Normal
    *d
    Max. High
    V100135
    45°
    V100136
    45°

    1. Connect 3 dry cell batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 3 (SHG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      for RHD 
      Tester Connection
      Sensor Condition
      Specified Condition
      3 (SHG) - 2 (SHRR)
      High (45°)
      4.4 to 4.6 V
      Normal (0°)
      2.3 to 2.6 V
      Low (-45°)
      0.4 to 0.6 V
      for LHD 
      Tester Connection
      Sensor Condition
      Specified Condition
      3 (SHG) - 2 (SHRL)
      High (45°)
      4.4 to 4.6 V
      Normal (0°)
      2.3 to 2.6 V
      Low (-45°)
      0.4 to 0.6 V

      NOTICE:
      Do not apply higher than 6 V.

      If the result is not as specified, replace the height control sensor.

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →