2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

NOTICE:
Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR WHEEL

3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

  1. C212872
    Disconnect the connector, and then detach the connector.

  1. Detach the clamp.

  1. C212873E01
    Place matchmarks on the link and bracket.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the nut and disconnect the sensor link.

  1. Remove the 2 bolts and height control sensor.

    NOTICE:
    Replace the rear height control sensor sub-assembly with a new one if it is dropped.


4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →