2013-2015 Land Cruiser Prado · Service Manual Steering

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL DRIVING SUPPORT SWITCH CONTROL ECU
  1. Install the driving support switch control ECU with the bolt.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the connector.


2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

B238219E01
  1. Connect each connector.

  1. Attach the 5 clips and claw to install the glove compartment door.

  1. Install the 2 bolts <C> and 2 screws <A> or <B>.

    Text in Illustration 
    *1
    Bolt
    *2
    Screw


3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.

  1. Install the screw.

    B298555E01

    Text in Illustration 
    *A
    for LHD
    *B
    for RHD


4. INSTALL INSTRUMENT PANEL ORNAMENT
  1. Attach the 5 clips to install the instrument panel ornament.


5. INSTALL INSTRUMENT SIDE PANEL RH
  1. Connect the connector.

  1. Attach the 5 clips, claw and 3 guides to install the instrument side panel.


6. INSTALL COWL SIDE TRIM BOARD RH
  1. Attach the clip and claw to install the cowl side trim board RH.

  1. Install the clip.


7. INSTALL DOOR SCUFF PLATE ASSEMBLY RH
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly RH.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


9. CHECK SRS WARNING LIGHT
(Click here)
← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →