INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL DRIVING SUPPORT SWITCH CONTROL ECU |
Install the driving support switch control ECU with the bolt.
- Torque:
- 13 N*m{ 127 kgf*cm , 9 ft.*lbf }
Connect the connector.
| 2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() ![]() |
Connect each connector.
Attach the 5 clips and claw to install the glove compartment door.
Install the 2 bolts <C> and 2 screws <A> or <B>.
Text in Illustration *1
Bolt
*2
Screw
| 3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.
Install the screw.


Text in Illustration *A
for LHD
*B
for RHD
| 4. INSTALL INSTRUMENT PANEL ORNAMENT |
Attach the 5 clips to install the instrument panel ornament.
| 5. INSTALL INSTRUMENT SIDE PANEL RH |
Connect the connector.
Attach the 5 clips, claw and 3 guides to install the instrument side panel.
| 6. INSTALL COWL SIDE TRIM BOARD RH |
Attach the clip and claw to install the cowl side trim board RH.
Install the clip.
| 7. INSTALL DOOR SCUFF PLATE ASSEMBLY RH |
Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly RH.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 9. CHECK SRS WARNING LIGHT |

