Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.
REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)
Detach the 2 hooks and disconnect the 2 rubber bands.
Apply protective tape to the locations shown in the illustration.
Text in Illustration
*1
Protective Tape
Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.
HINT:
Tape the screwdriver tip before use.
Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 front seatback board clips from the front seatback board sub-assembly LH.
Text in Illustration
*1
Protective Tape
*a
Point (A)
Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.
2.
REMOVE FRONT SEATBACK BOARD CLIP (w/ Seatback Board)
Remove the 2 front seatback board clips from the separate type front seatback spring assembly.
3.
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.
4.
REMOVE RECLINING POWER SEAT SWITCH KNOB
Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.
5.
REMOVE FRONT SEAT CUSHION SHIELD LH
Disconnect the lifter motor connector.
Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.
Detach the clip of the front seat No. 1 inner cushion shield LH.
Using a moulding remover, detach the 3 claws and guide.
Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.
Detach the 3 claws and open the wire harness cover.
Detach the 3 wire harness clamps and disconnect the seat wire connector.
6.
REMOVE FRONT POWER SEAT SWITCH LH
Remove the 3 screws.
w/ Seat Memory System: Disconnect the 2 power seat switch connectors and remove the front power seat switch LH.
w/o Seat Memory System: Disconnect the power seat switch connector and remove the front power seat switch LH.