2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)

  1. B357440
    Detach the 2 hooks and disconnect the 2 rubber bands.

  1. B341419E03
    Apply protective tape to the locations shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. B341416E03
    Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.

    HINT:
    Tape the screwdriver tip before use.

  1. Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 front seatback board clips from the front seatback board sub-assembly LH.

    Text in Illustration 
    *1
    Protective Tape
    *a
    Point (A)

  1. B247916
    Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.


2. REMOVE FRONT SEATBACK BOARD CLIP (w/ Seatback Board)

  1. B357441
    Remove the 2 front seatback board clips from the separate type front seatback spring assembly.


3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B239530
  1. Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.


4. REMOVE RECLINING POWER SEAT SWITCH KNOB

B239532
  1. Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.


5. REMOVE FRONT SEAT CUSHION SHIELD LH
  1. Disconnect the lifter motor connector.

  1. Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.

  1. Detach the clip of the front seat No. 1 inner cushion shield LH.

  1. Using a moulding remover, detach the 3 claws and guide.

  1. Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.

    B239534

  1. B239536
    Detach the 3 claws and open the wire harness cover.

  1. Detach the 3 wire harness clamps and disconnect the seat wire connector.


6. REMOVE FRONT POWER SEAT SWITCH LH
  1. Remove the 3 screws.

  1. B239589
    w/ Seat Memory System:
    Disconnect the 2 power seat switch connectors and remove the front power seat switch LH.

  1. B239537
    w/o Seat Memory System:
    Disconnect the power seat switch connector and remove the front power seat switch LH.


7. REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)

B239538
  1. Using a screwdriver, detach the 2 claws.

  1. Disconnect the lumbar switch connector and remove the lumbar switch.


8. REMOVE FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

B239540
  1. Detach the 2 claws and remove the front seat No. 1 inner cushion shield LH.


9. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

B239167
  1. Using a moulding remover, detach the 3 claws and remove the front seat inner cushion shield LH.


10. REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)

B239169
  1. Using a moulding remover, detach the 4 claws and remove the front seat inner cushion shield RH.


11. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. for Driver Side:
    (Click here)

  1. for Front Passenger Side:
    (Click here)


12. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

  1. w/o Seatback Board:

    1. B239173
      Disconnect the rubber band.

  1. B241809
    Detach the clamp and disconnect the No. 2 seat wire.

  1. B241810
    w/ Seat Heater System:
    Disconnect the seat heater connector and detach the seat heater wire harness clamp.

  1. B239177
    Detach the 2 hooks.

  1. B239174E01
    w/ Front Seat Side Airbag:

    1. Detach the claw and disconnect the airbag connector.

    2. Detach the 3 airbag wire harness clamps.

    3. Detach the fastening tape and open the cover.

      Text in Illustration 
      *1
      Fastening Tape

    4. Disconnect the airbag wire harness.

  1. B239178
    Remove the 4 bolts and seatback assembly.


13. REMOVE SEAT ADJUSTER COVER CAP

B239170
  1. Remove the 2 seat adjuster cover caps.


14. REMOVE FRONT SEAT LEG COVER LH

B239171
  1. Detach the 2 claws.

  1. Move the front seat leg cover LH in the direction of the arrow to remove it.


15. REMOVE SEAT CUSHION COVER WITH PAD

  1. B239179
    w/ Seat Heater System:
    Disconnect the seat heater connector and detach the 3 seat heater wire harness clamps.

  1. Detach the hooks.

    B239180

  1. B239181
    for Front Passenger Side:
    Detach the claw and disconnect the connector.

  1. Remove the seat cushion cover with pad.


16. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

  1. B372264
    Type A:

    1. Remove the hog rings and disconnect the straps.

  1. B372267E01
    Type B:

    1. Cut off the tack pins and disconnect the straps.

      Text in Illustration 
      *1
      Tack Pin

  1. B239182
    Remove the 15 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.


17. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)

B239184E01
  1. Cut off the tack pins and remove the front seat cushion heater from the front seat cushion cover.

    Text in Illustration 
    *1
    Tack Pin


18. REMOVE RECLINING ADJUSTER INSIDE COVER LH

B239542
  1. Detach the claw and guide, and then remove the reclining adjuster inside cover LH.


19. REMOVE FRONT SEAT LOWER CUSHION SHIELD LH

B239543
  1. Remove the screw.

  1. Detach the hook and clip, and then remove the front seat lower cushion shield LH.


20. REMOVE FRONT SEAT LOWER CUSHION SHIELD RH
  1. Remove the screw.

  1. Detach the hook and clip, and then remove the front seat lower cushion shield RH.


21. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH

B239188
  1. Remove the screw.

  1. Move the front seat cushion edge protector LH in the direction of the arrow to detach the hook and remove the front seat cushion edge protector LH.


22. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH

HINT:
Use the same procedure described for the LH side.


23. REMOVE SEAT CUSHION CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)

  1. B357445
    Detach the 2 clamps and 2 claws, and then remove the seat cushion climate control duct LH.


24. REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH (w/ Climate Control Seat System)

  1. B357250
    Remove the 2 screws and seat cushion climate control bracket.

  1. Disconnect the connector.

  1. B357446
    Detach the 2 guides and remove the seat cushion climate control blower assembly LH as shown in the illustration.


25. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)

B239190
  1. Disconnect the connector.

  1. Detach the 2 clamps and remove the seat heater control.


26. REMOVE FRONT SEAT WIRE LH
  1. Remove the seat wire LH.


27. REMOVE RECLINING ADJUSTER INSIDE COVER LH

B239544
  1. Detach the guide and remove the reclining adjuster inside cover LH.


28. REMOVE RECLINING ADJUSTER INSIDE COVER RH
  1. Detach the guide and remove the reclining adjuster inside cover RH.


29. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

  1. w/o Seatback Board:

    1. B239192
      Remove the 3 hog rings.

    2. Open the 2 fasteners, and then open the seatback cover.

      B242232E01

      Text in Illustration 
      *A
      for Cloth Seat
      *B
      for Leather Seat

  1. w/ Seatback Board:

    1. B357448
      Detach the hooks.

    2. B247933
      Remove the 5 hog rings.

  1. B239201
    w/ Front Seat Side Airbag:

    1. Remove the nut and seatback cover bracket from the seat frame.

    2. Disconnect the seatback cover bracket from the separate type front seatback pad.

  1. B239198
    Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.

  1. B239205
    Remove the 13 hog rings and separate type front seatback cover.


30. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)

B239207E01
  1. Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.

    Text in Illustration 
    *1
    Tack Pin


31. REMOVE SEPARATE TYPE FRONT SEATBACK PAD
  1. Remove the separate type front seatback pad.


32. REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)

  1. B357248
    Disconnect the connector.

  1. Remove the 4 screws and seatback climate control blower LH.


33. REMOVE SEATBACK CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)

  1. B357249
    Detach the 2 claws and remove the seatback climate control duct LH.


34. REMOVE NO. 2 SEAT WIRE

  1. for Driver Side:
    w/o Climate Control Seat System:

    1. B241803
      Disconnect the 2 connectors.

    2. Detach the 2 clamps and remove the No. 2 seat wire.

  1. for Driver Side:
    w/ Climate Control Seat System:

    1. B357451
      Disconnect the 2 connectors.

    2. Detach the 3 clamps and remove the No. 2 seat wire.

  1. for Front Passenger Side:

    1. Disconnect the connector.

    2. Detach the 2 clamps and remove the seat wire.


35. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Front Seat Side Airbag)

CAUTION:
When storing the front seat side airbag assembly, keep the airbag deployment side facing upward.

HINT:
Use the same procedure for the RH and LH sides.

  1. B251815
    Detach the 2 clamps.

  1. B333276
    Remove the 2 nuts and front seat side airbag assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.

← DISASSEMBLY (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →