2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B239530
  1. Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.


3. REMOVE RECLINING POWER SEAT SWITCH KNOB

B239532
  1. Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.


4. REMOVE FRONT SEAT CUSHION SHIELD LH
  1. Disconnect the lifter motor connector.

  1. Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.

  1. Detach the clip of the front seat No. 1 inner cushion shield LH.

  1. Using a moulding remover, detach the 3 claws and guide.

  1. Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.

    B239534

  1. B239536
    Detach the 3 claws and open the wire harness cover.

  1. Detach the 3 wire harness clamps and disconnect the seat wire connector.


5. REMOVE FRONT POWER SEAT SWITCH LH

B239537
  1. Remove the 3 screws.

  1. Disconnect the power seat switch connector and remove the switch.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →