2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).


2. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

  1. B239173
    Remove the rubber band from the seat cushion spring.

  1. B241810
    Disconnect the seat heater connector and detach the wire harness clamp.

  1. B239192
    Remove the 3 hog rings.

  1. Open the 2 fasteners, and then open the seatback cover.

    B242232E01

    Text in Illustration 
    *A
    for Cloth Seat
    *B
    for Leather Seat

  1. B239201
    w/ Front Seat Side Airbag:

    1. Remove the nut and seatback cover bracket from the seat frame.

    2. Disconnect the seatback cover bracket from the seatback pad.

  1. B239198
    Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.

  1. Remove the hog rings and front seatback cover.

    HINT:
    The number of hog rings differs according to seat type.


    B242230E01
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B


3. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH

B239207E01
  1. Cut off the tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.

    Text in Illustration 
    *1
    Tack Pin

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →