2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL REAR SEAT ASSEMBLY LH

B237613E01
  1. Place the rear seat assembly LH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    Be sure to install the seat with the seatback folded down.

  1. Connect the center inner belt to the rear seat assembly.

  1. Temporarily install the seat with the 5 bolts and nut.

  1. Tighten the bolts and nut in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. w/ Seat Heater System:
    Connect the seat heater connector.


2. INSTALL SEAT TRACK COVER LH

B237611
  1. Attach the 3 clips to install the seat track cover LH.


3. INSTALL SEAT TRACK INNER BRACKET COVER LH

B237612
  1. Attach the 6 clips to install the seat track inner bracket cover LH.


4. INSTALL REAR SEAT OUTER TRACK BRACKET COVER

B237607
  1. Move the cover in the direction of the arrow to attach the 2 guides.

  1. Attach the 2 claws to install the rear seat outer track bracket cover.


5. INSTALL REAR SEAT TRACK INNER BRACKET COVER

B237609
  1. Attach the 2 claws and guide to install the rear seat track inner bracket cover.


6. INSTALL REAR SEAT HEADREST ASSEMBLY
  1. Install the rear seat headrest assembly.

← REASSEMBLY (from Aug 2013)COMPONENTS (from Aug 2013) →