2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE REAR SEAT HEADREST ASSEMBLY
  1. Remove the rear seat headrest assembly.


2. REMOVE REAR SEAT TRACK INNER BRACKET COVER

B237608
  1. Using moulding remover A, detach the 2 claws and guide, and then remove the rear seat track inner bracket cover.


3. REMOVE REAR SEAT OUTER TRACK BRACKET COVER

B237606
  1. Using moulding remover A, detach the 2 claws.

  1. Move the cover in the direction of the arrow to detach the 2 guides, and then remove the rear seat outer track bracket cover.


4. REMOVE SEAT TRACK INNER BRACKET COVER LH

B237612
  1. Using a clip remover, detach the 6 clips and remove the seat track inner bracket cover LH.


5. REMOVE SEAT TRACK COVER LH

B237610
  1. Using a clip remover, detach the 3 clips and remove the seat track cover LH.


6. REMOVE REAR SEAT ASSEMBLY LH
  1. w/ Seat Heater System:
    Disconnect the seat heater connector.

  1. B237788
    Disconnect the center inner seat belt from the rear seat assembly.

  1. Remove the 5 bolts, nut and rear seat assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.

    HINT:
    Be sure to remove the seat with the seatback folded down.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →