2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH

B241731E01
  1. Install the inner belt with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.

    Text in Illustration 
    *a
    Protruding Part


2. INSTALL REAR SEAT CUSHION MOULDING RH
  1. Attach the 2 guides and 3 claws to install the rear seat rear cushion moulding LH.

  1. Install the screw.


3. INSTALL REAR SEAT ASSEMBLY RH
  1. Install the rear seat assembly RH (Click here).

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →