2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE FRONT BUMPER LOWER COVER
  1. Remove the clip, 5 bolts and front bumper lower cover.


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts and No. 1 engine under cover.


3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. A218364
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug.

    A218365E01

    Text in Illustration 
    *1
    Radiator Reservoir
    *2
    Vent Plug
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Drain Cock Plug


4. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

  1. Wipe the oil pan and drain plug.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    34 N*m{ 347 kgf*cm , 25 ft.*lbf }


5. REMOVE STARTER ASSEMBLY
  1. for 2.2 kW Type:
    Remove the starter (Click here).

  1. for 2.7 kW Type:
    Remove the starter (Click here).

  1. for 3.0 kW Type:
    Remove the starter (Click here).


6. REMOVE COMMON RAIL ASSEMBLY
  1. Remove the common rail (Click here).


7. REMOVE SUPPLY PUMP ASSEMBLY
  1. Remove the supply pump (Click here).


8. REMOVE VACUUM CONTROL VALVE SET

  1. A152488
    Disconnect the 2 VSV connectors and 3 vacuum hoses.

  1. Remove the 2 bolts and vacuum control valve set.


9. DISCONNECT NO. 3 WATER BY-PASS HOSE (w/ EGR Cooler)

  1. A224153
    Disconnect the No. 3 water by-pass hose.


10. REMOVE OIL FILTER SUB-ASSEMBLY

  1. A227248E01
    Using SST, remove the oil filter.
    SST
    09228-07501  


11. REMOVE OIL COOLER COVER SUB-ASSEMBLY
  1. Disconnect the oil pressure switch connector.

  1. Disconnect the vinyl tube.

  1. A224154
    Remove the 2 nuts and disconnect the No. 2 vacuum transmitting pipe from the oil cooler cover.

  1. A224155
    Remove the 13 bolts and oil cooler cover.


12. REMOVE OIL COOLER ASSEMBLY

  1. A224157
    Loosen the 4 nuts.

  1. Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.

  1. Remove the 4 nuts, oil cooler and 2 gaskets.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →