2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE FRONT BUMPER LOWER COVER
  1. Remove the clip, 5 bolts and front bumper lower cover.


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts and No. 1 engine under cover.


3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. A218364
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug.

    A218365E01

    Text in Illustration 
    *1
    Radiator Reservoir
    *2
    Vent Plug
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Drain Cock Plug


4. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

  1. Wipe the oil pan and drain plug.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    34 N*m{ 347 kgf*cm , 25 ft.*lbf }


5. REMOVE COMMON RAIL ASSEMBLY
(Click here)

6. REMOVE STARTER ASSEMBLY
  1. for 2.2 kW Type: (Click here)
  2. for 2.7 kW Type: (Click here)

7. REMOVE OIL COOLER COVER SUB-ASSEMBLY
  1. Disconnect the oil pressure sender gauge connector.

  1. Disconnect the vinyl tube.

  1. A247145
    Remove the 2 nuts and disconnect the No. 2 vacuum transmitting pipe from the oil cooler cover.

  1. A247146
    Remove the 13 bolts, oil cooler cover and gasket.


8. REMOVE OIL COOLER ASSEMBLY

  1. A224157
    Loosen the 4 nuts.

  1. Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.

  1. Remove the 4 nuts, oil cooler and 2 gaskets.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →