2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the RH side.


1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the seat wire connectors under the seat.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the seat track adjusting handle to move the seat to the rearmost position.

  1. B241191E01
    Tighten the bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Operate the seat track adjusting handle to move the seat to the foremost position.

  1. B241190E01
    Tighten the bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


2. INSTALL SEAT TRACK COVER RH

B241187
  1. Move the cover in the direction of the arrow to attach the 2 guides.

  1. Attach the 2 claws to install the cover.


3. INSTALL INNER SEAT TRACK BRACKET COVER RH

B241189
  1. Move the cover in the direction of the arrow to attach the 2 guides.

  1. Attach the 2 claws to install the cover.


4. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER RH
  1. Operate the seat track adjusting handle to move the seat to the rearmost position.

  1. B241184
    Move the cover in the direction of the arrow to attach the guide.

  1. Attach the 2 claws to install the cover.


5. INSTALL FRONT SEAT INNER TRACK BRACKET COVER RH

B241183
  1. Attach the 2 claws to install the cover.


6. INSTALL FRONT SEAT HEADREST ASSEMBLY

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


8. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).


9. INSPECT FRONT SEAT ASSEMBLY
  1. w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch to ON.

    2. Turn the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

← REASSEMBLY (from Aug 2014)INSTALLATION (from Aug 2014) →