INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the RH side.
- Use the same procedure for RHD and LHD vehicles.
| 1. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
Connect the seat wire connectors under the seat.
Temporarily install the front seat assembly with the 4 bolts.
Operate the seat track adjusting handle to move the seat to the rearmost position.
Tighten the bolts in the order indicated in the illustration.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Operate the seat track adjusting handle to move the seat to the foremost position.
Tighten the bolts in the order indicated in the illustration.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
| 2. INSTALL SEAT TRACK COVER RH |
![]() ![]() |
Move the cover in the direction of the arrow to attach the 2 guides.
Attach the 2 claws to install the cover.
| 3. INSTALL INNER SEAT TRACK BRACKET COVER RH |
![]() ![]() |
Move the cover in the direction of the arrow to attach the 2 guides.
Attach the 2 claws to install the cover.
| 4. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER RH |
Operate the seat track adjusting handle to move the seat to the rearmost position.
Move the cover in the direction of the arrow to attach the guide.

Attach the 2 claws to install the cover.
| 5. INSTALL FRONT SEAT INNER TRACK BRACKET COVER RH |
![]() ![]() |
Attach the 2 claws to install the cover.
| 6. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 8. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).
| 9. INSPECT FRONT SEAT ASSEMBLY |
w/ Seat Heater System:
Check the seat heater operation.Turn the ignition switch to ON.
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.



