REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1.
REMOVE DOOR SCUFF PLATE ASSEMBLY RH
|
 |
- HINT:
- Use the same procedure described for the LH side.
| 2.
REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
|
 |
- HINT:
- Use the same procedure described for the LH side.
| 3.
REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
|
 |
Remove the tonneau cover.
| 4.
REMOVE MAT SET PLATE COVER
|
 |
- HINT:
- Use the same procedure for all mat set plate covers.
Using a screwdriver, detach the 2 claws and remove the mat set plate cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective tape
|
| 5.
REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
|
 |
Remove the 5 screws.
Detach the 6 claws and remove the rear floor mat rear support plate.
| 6.
REMOVE QUARTER TRIM COVER HOLE RH
|
 |
- HINT:
- Use the same procedure described for the LH side.
| 7.
REMOVE REAR FLOOR CARPET ASSEMBLY
|
 |
Remove the rear floor carpet.
| 8.
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
|
 |
- HINT:
- Use the same procedure for the other No. 1 luggage compartment trim hook.
Remove the luggage compartment trim hook by turning it clockwise.
| 9.
REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
|
 |
- HINT:
- Use the same procedure for the other tonneau cover holder cap.
Using a screwdriver, detach the 2 claws and remove the tonneau cover holder cap.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective tape
|
| 10.
REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
|
 |
- HINT:
- Use the same procedure for the other front deck side trim cover.
Using a screwdriver, detach the 2 claws and remove the front deck side trim cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective tape
|
| 11.
REMOVE QUARTER TRIM POCKET TRAY
|
 |
Put protective tape around the quarter trim pocket tray.
Using a screwdriver, detach the 6 claws and 2 guides, and remove the quarter trim pocket tray.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective tape
|
| 12.
REMOVE OUTER LAP BELT ANCHOR COVER
|
 |
- HINT:
- Use the same procedure for the other outer lap belt anchor cover.
Detach the 3 claws and remove the outer lap belt anchor cover.
| 13.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
|
 |
Remove the bolt and disconnect the front seat outer belt floor anchor.
- Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips.
Disconnect the connector and remove the deck trim side panel.


| 14.
REMOVE VOLTAGE INVERTER ASSEMBLY |
 |
- Disconnect the connector.
Remove the 2 bolts and voltage inverter.