ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT VOLTAGE INVERTER ASSEMBLY |
- HINT:
- Remove interior parts so that the voltage inverter can be seen.
Disconnect the voltage inverter connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
Q17-5 (IG) - Q17-1 (GND)
Engine switch on (IG)
11 to 14 V
Q17-1 (GND) - Body ground
Always
Below 1 V
Text in Illustration *a
Front view of wire harness connector
(to Voltage Inverter Assembly)
Reconnect the voltage inverter connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
Q17-4 (AC1) - Q17-8 (AC2)
Engine switch on (IG), main switch on
AC 220 V
Text in Illustration *a
Component with harness connected
(Voltage Inverter Assembly)
