2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH

E197682E04
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      3 (ECU) - 6 (IG)
      Sonar switch off
      10 kΩ or higher
      Sonar switch on
      Below 1 Ω

  1. Inspect the indicator operation.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3 (ECU)
    Battery negative (-) → Terminal 7 (IND)
    LED illuminates

    If the result is not as specified, replace the back sonar or clearance sonar switch.

  1. Inspect the illumination operation.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 5 (ILL+)
    Battery negative (-) → Terminal 4 (ILL-)
    LED illuminates

    If the result is not as specified, replace the back sonar or clearance sonar switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Back Sonar or Clearance Sonar Switch)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →