2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY

  1. E199745
    Remove the 6 screws and console compartment door sub-assembly.


2. REMOVE CONSOLE COMPARTMENT DOOR HINGE SUB-ASSEMBLY

  1. E197106
    Remove the 6 screws.

  1. E204236E01
    Put protective tape around the instrument side panel.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 claws.

  1. E197108
    Remove the 4 screws the console compartment door hinge sub-assembly.


3. REMOVE CONSOLE BOX REGISTER ASSEMBLY

B238170
  1. Detach the 4 claws and remove the console box register.


4. REMOVE COOLING BOX ASSEMBLY

  1. E204231
    Remove the 6 screws.

  1. Detach the 12 claws and remove the cooling box assembly.


5. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

  1. E197114
    Remove the 2 screws.

  1. Disconnect the connector and remove the air conditioning amplifier assembly.


6. REMOVE NO. 3 COOLER UNIT DRAIN HOSE

  1. E197120
    Remove the No. 3 cooler unit drain hose.


7. REMOVE NO. 1 COOLER WIRING HARNESS SUB-ASSEMBLY
  1. Remove the packing.

  1. E199753
    Disconnect the 3 connectors and remove the No. 1 cooler wiring harness sub-assembly.


8. REMOVE COOLER CONTROL SWITCH SUB-ASSEMBLY

  1. E197115
    Detach the 2 claws and remove the cooler control switch sub-assembly.


9. REMOVE COOLING UNIT DOOR
  1. Remove the packing.

  1. E199744
    Remove the 8 screws, 2 bolts and cooling unit door.


10. REMOVE NO. 2 COOLER EVAPORATOR SUB-ASSEMBLY

  1. E200770
    Remove the 3 screws, 5 bolts and air duct.

  1. Remove the 5 holding springs.

  1. E197116
    Remove the 4 bolts.

  1. E197118
    Remove the cooling unit case.

  1. E197119
    Remove the cooler evaporator assembly.

  1. E197121
    Detach the 2 claws.

  1. E197123
    Loosen the 2 nuts and remove the No. 1 liquid tube, cooler magnet valve assembly and No. 2 evaporator sub-assembly.


11. REMOVE NO. 1 COOLER BLOWER FAN

  1. E199755
    Detach the 4 claws and remove the blower fan cover.

  1. E199756
    Detach the spline and remove the No. 1 cooler blower fan.


12. REMOVE NO. 1 COOLER BLOWER MOTOR SUB-ASSEMBLY
  1. Detach the 3 claws and remove the No. 1 cooler blower motor sub-assembly.

← REMOVAL (from Aug 2014)REASSEMBLY (from Aug 2013) →