2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT VACUUM SWITCHING VALVE (for EGR Cut)

  1. A099942E05
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    37 to 44 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    1 MΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Vacuum Switching Valve)
    If the result is not as specified, replace the vacuum switching valve.

  1. Check operation of the vacuum switching valve.

    1. A151248E03
      Attach a vacuum pump to port E and check that vacuum does not flow from the filter to port E.
      Text in Illustration 
      *1
      Port E
      *2
      Filter

    2. A151249E03
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Filter

    3. Attach a vacuum pump to port E and check that vacuum flows from the filter to port E.
      If the result is not as specified, replace the vacuum switching valve.


INSPECT VACUUM SWITCHING VALVE (for EGR Bypass Valve)

  1. A222590E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    37 to 44 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    1 MΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Vacuum Switching Valve)
    If the result is not as specified, replace the vacuum switching valve.

  1. A222591E01
    Check operation of the vacuum switching valve.

    1. When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.

      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Vacuum
      *4
      Air
      *5
      Filter

    2. A222592E01
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Air

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the vacuum switching valve.

← ON-VEHICLE INSPECTION (from Aug 2013)ON-VEHICLE INSPECTION (from Aug 2013) →