2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT VACUUM SWITCHING VALVE (for EGR Bypass Valve)

  1. A222590E01
    Inspect the No. 1 and No. 2 vacuum switching valves.
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    33 to 39 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Vacuum Switching Valve)
    If the result is not as specified, replace the vacuum switching valve.

  1. A222591E01
    Check operation of the No. 1 and No. 2 vacuum switching valves.

    1. When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.

      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Vacuum
      *4
      Air
      *5
      Filter

    2. A222592E01
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Air

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the vacuum switching valve.

← INSTALLATION (from Aug 2013)ON-VEHICLE INSPECTION (from Aug 2013) →