2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL INPUT SHAFT FRONT BEARING

  1. D029020E01
    Using SST and a press, install a new front bearing to the input shaft.
    SST
    09950-60010   (09951-00570)
    09950-70010   (09951-07100)

    NOTICE:
    Be sure to install the input shaft front bearing with the snap ring groove on the front side.


2. INSTALL FRONT BEARING SHAFT SNAP RING
  1. Select a snap ring that makes the clearance between the input shaft and front bearing within the specification.

    Standard clearance:
    0.10 mm (0.00394 in.) or less

    Snap Ring Thickness:
    Thickness
    2.10 mm (0.0827 in.)
    2.15 mm (0.0846 in.)
    2.20 mm (0.0866 in.)
    2.25 mm (0.0886 in.)
    2.30 mm (0.0906 in.)
    2.35 mm (0.0925 in.)
    2.40 mm (0.0945 in.)

  1. D026115E02
    Using a snap ring expander, install the snap ring.


3. INSTALL INPUT SHAFT BEARING

  1. D026114E02
    Apply gear oil to the input shaft bearing and install it to the input shaft.


4. INSTALL NO. 2 SYNCHRONIZER RING

  1. D026113E02
    Apply gear oil to No. 2 synchronizer ring and install it to the input shaft.

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →