REASSEMBLY
Removal / installation · Vehicles built from Aug 2013
- HINT:
- When installing the back door outside garnish protector, heat the rear lower license plate bracket and back door ornament surface using a heat light.
- Standard:
Item
Temperature
Rear Lower License Plate Bracket
20 to 30°C (68 to 86°F)
Back Door Ornament
20 to 30°C (68 to 86°F)
- NOTICE:
- Do not heat the back door outside garnish excessively.
| 1. INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR |
for Rear Lower License Plate Bracket:
When using a new rear lower license plate bracket:
- Clean the rear lower license plate bracket surface.
- Using a heat light, heat the rear lower license plate bracket surface.
- Clean the rear lower license plate bracket surface.
When reusing the rear lower license plate bracket:
- Using a heat light, heat the rear lower license plate bracket surface.
- Remove the double-sided tape from the rear lower license plate bracket.
- Wipe off any tape adhesive residue with cleaner.
- Using a heat light, heat the rear lower license plate bracket surface.
Install the back door outside garnish protector.
for Rear License Light Cover:
When using a new back door ornament:
- Clean the rear back door ornament surface.
- Using a heat light, heat the back door ornament surface.
- Clean the rear back door ornament surface.
When reusing the back door ornament:
- Using a heat light, heat the back door ornament surface.
- Remove the double-sided tape from the back door ornament.
- Wipe off any tape adhesive residue with cleaner.
- Using a heat light, heat the back door ornament surface.
Install the back door outside garnish protector.
| 2. INSTALL BACK DOOR ORNAMENT |
Attach the 6 claws to install the back door ornament.
| 3. INSTALL LUGGAGE ELECTRICAL KEY SWITCH (w/ Entry and Start System) |
Attach the 2 guides to install the back door electrical key switch.
Install the 2 screws.
| 4. INSTALL LICENSE PLATE LIGHT ASSEMBLY |
Install the license plate light with the 4 screws.
| 5. INSTALL REAR LICENSE LIGHT COVER |
Install the rear license light cover with the 5 screws.
| 6. INSTALL LICENSE PLATE LIGHT CORD (w/o Entry and Start System) |
Connect the connector to install the license plate cord.
