2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE LICENSE PLATE LIGHT CORD (w/o Entry and Start System)

B237842
  1. Disconnect the connector and remove the license plate light cord.


2. REMOVE REAR LICENSE LIGHT COVER

B237899
  1. Remove the 5 screws and rear license light cover.


3. REMOVE LUGGAGE ELECTRICAL KEY SWITCH (w/ Entry and Start System)

  1. B241159
    Remove the 2 screws.

  1. Detach the 2 guides and remove the back door electrical key switch.


4. REMOVE LICENSE PLATE LIGHT ASSEMBLY

B237900
  1. Remove the 4 screws and license plate light.


5. REMOVE BACK DOOR ORNAMENT

B237901E01
  1. Put protective tape around the back door ornament.

  1. Using a moulding remover, detach the 6 claws and remove the back door ornament.

    NOTICE:
    Tape the moulding remover tip before use.

    Text in Illustration 
    *1
    Protective Tape


6. REMOVE BACK DOOR OUTSIDE GARNISH PROTECTOR

  1. B241007
    for Rear Lower License Plate Bracket Stay:
    Remove the back door outside garnish protector.

  1. B241008
    for Rear License Light Cover:
    Remove the back door outside garnish protector.

← REMOVAL (from Aug 2014)REASSEMBLY (from Aug 2013) →