2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

NOTICE:
  1. Avoid any impact to the blind spot monitor sensor.
  2. Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL BLIND SPOT MONITOR SENSOR LH
  1. Connect the connector.

  1. Install the blind spot monitor sensor LH with the 3 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


2. INSTALL BLIND SPOT MONITOR SENSOR RH
  1. Connect the connector.

  1. Install the blind spot monitor sensor RH with the 3 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


3. INSTALL REAR BUMPER COVER
  1. w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Connect the 4 connectors.

  1. w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Connect the 2 connectors.

  1. w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Connect the 2 connectors.

  1. Attach the 14 claws to install the rear bumper cover.

  1. Install the 6 bolts and 2 clips.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


4. INSTALL REAR QUARTER PANEL MUDGUARD LH
  1. Install the rear quarter panel mudguard with the 5 screws and 2 clips.


5. INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure described for the LH side.


6. INSTALL NO. 1 REAR BUMPER PLATE
  1. Attach the 10 claws and 10 guides to install the No. 1 rear bumper plate.


7. INSTALL BACK DOOR CHECK

  1. Bumper side:

    1. B246611E01
      Install the back door check with back door lower damper stay bracket with the 2 bolts labeled A.

      Torque:
      30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    2. Install the bolt labeled B.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    3. Attach the wire harness.

  1. Back door side:

    1. B340680
      Attach the clip to install the back door check with back door lower damper stay bracket.

    2. Install the 2 bolts.

      Torque:
      30 N*m{ 306 kgf*cm , 22 ft.*lbf }


8. INSTALL REAR BUMPER BAR PLATE
  1. Attach the 14 claws to install the rear bumper bar plate.


9. INSTALL JACK BOX HOLE COVER
  1. Attach the 2 claws to install the jack box hole cover.


10. INSTALL PINTLE HOOK ASSEMBLY (w/ Pintle Hook)
  1. Install the pintle hook with the 4 bolts and 4 nuts.

    Torque:
    81 N*m{ 826 kgf*cm , 60 ft.*lbf }

  1. For vehicles with a spare tire installed to the underbody, install the spare tire.

← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →