INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- NOTICE:
- Avoid any impact to the blind spot monitor sensor.
- Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
- Avoid any impact to the blind spot monitor sensor.
- HINT:
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
| 1. INSTALL BLIND SPOT MONITOR SENSOR LH |
Connect the connector.
Install the blind spot monitor sensor LH with the 3 nuts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 2. INSTALL BLIND SPOT MONITOR SENSOR RH |
Connect the connector.
Install the blind spot monitor sensor RH with the 3 nuts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 3. INSTALL REAR BUMPER COVER |
w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 4 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
Connect the 2 connectors.
w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 2 connectors.
Attach the 14 claws to install the rear bumper cover.
Install the 6 bolts and 2 clips.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
| 4. INSTALL REAR QUARTER PANEL MUDGUARD LH |
Install the rear quarter panel mudguard with the 5 screws and 2 clips.
| 5. INSTALL REAR QUARTER PANEL MUDGUARD RH |
- HINT:
- Use the same procedure described for the LH side.
| 6. INSTALL NO. 1 REAR BUMPER PLATE |
Attach the 10 claws and 10 guides to install the No. 1 rear bumper plate.
| 7. INSTALL BACK DOOR CHECK |
Bumper side:
Install the back door check with back door lower damper stay bracket with the 2 bolts labeled A.

- Torque:
- 30 N*m{ 306 kgf*cm , 22 ft.*lbf }
Install the bolt labeled B.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Attach the wire harness.
Back door side:
Attach the clip to install the back door check with back door lower damper stay bracket.

Install the 2 bolts.
- Torque:
- 30 N*m{ 306 kgf*cm , 22 ft.*lbf }
| 8. INSTALL REAR BUMPER BAR PLATE |
Attach the 14 claws to install the rear bumper bar plate.
| 9. INSTALL JACK BOX HOLE COVER |
Attach the 2 claws to install the jack box hole cover.
| 10. INSTALL PINTLE HOOK ASSEMBLY (w/ Pintle Hook) |
Install the pintle hook with the 4 bolts and 4 nuts.
- Torque:
- 81 N*m{ 826 kgf*cm , 60 ft.*lbf }
For vehicles with a spare tire installed to the underbody, install the spare tire.
