2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL REFRESHING SEAT SWITCH (for Automatic Transmission)
  1. Attach the 4 claws to install the 2 refreshing seat switches.

  1. Connect the 2 connectors.


2. INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)
  1. Connect each connector.

  1. Attach the 8 clips and 2 claws to install the console panel.


3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)

B363299E01
  1. Install the shift lever knob and twist it in the direction indicated by the arrow.

  1. Install the shifting hole cover to the shift lever knob.

    Text in Illustration 
    *1
    Shifting Hole Cover


4. INSTALL REFRESHING SEAT SWITCH (for Manual Transmission)
  1. Attach the 2 claws to install the refreshing seat switch.

    HINT:
    Use the same procedure to install the refreshing seat switch on the other side.


5. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
  1. w/o Seat Heater System:

    1. Connect the connector.

    2. Attach the 5 clips to install the front console upper panel garnish.

  1. w/o CRAWL:

    1. Connect each connector.

    2. Attach the 5 clips to install the front console upper panel garnish.

  1. w/ CRAWL:

    1. Attach the 5 clips to install the front console upper panel garnish.


6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
  1. Attach the 4 clips to install the instrument panel finish panel end LH.


7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
  1. Attach the 4 clips to install the instrument panel finish panel end RH.


8. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
  1. Attach the 5 clips to install the No. 2 instrument panel finish panel cushion.


9. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION

HINT:
Use the same procedure described for the No. 2 instrument panel finish panel cushion.


10. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
  1. Connect the connector.

  1. Attach the 4 clips to install the integration control and panel assembly.

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →