2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT REFRESHING SEAT SWITCH LH

  1. B359327E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (BLLH) - 11 (SW-)
    Switch off
    1.5 to 2.8 kΩ
    Switch on (HI)
    29 to 54 Ω

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the refreshing seat switch LH.
    Text in Illustration 
    *a
    Component without harness connected
    (Refreshing Seat Switch LH)

  1. Apply battery voltage to the switch connector, and check that the refreshing seat switch LH illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 3 (ILL+)
    Battery negative (-) → 5 (ILL-)
    Illuminates

    If the result is not as specified, replace the refreshing seat switch LH.

  1. Apply battery voltage to the switch connector, and check that the refreshing seat switch LH indicator illuminates.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → 8 (IG)
    Battery negative (-) → 10 (E)
    Switch on
    Indicator illuminates

    If the result is not as specified, replace the refreshing seat switch LH.


INSPECT REFRESHING SEAT SWITCH RH

  1. B359328E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (BLRH) - 11 (SVSG)
    Switch off
    1.5 to 2.8 kΩ
    Switch on (HI)
    29 to 54 Ω

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the refreshing seat switch RH.
    Text in Illustration 
    *a
    Component without harness connected
    (Refreshing Seat Switch RH)

  1. Apply battery voltage to the switch connector, and check that the refreshing seat switch RH illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 3 (ILL+)
    Battery negative (-) → 5 (ILL-)
    Illuminates

    If the result is not as specified, replace the refreshing seat switch RH.

  1. Apply battery voltage to the switch connector, and check that the refreshing seat switch RH indicator illuminates.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → 8 (IG)
    Battery negative (-) → 10 (E)
    Switch on
    Indicator illuminates

    If the result is not as specified, replace the refreshing seat switch RH.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →