REMOVAL
Removal / installation · Vehicles built from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
Detach the 4 clips.

Disconnect the connector and remove the integration control and panel assembly.
| 2. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
![]() ![]() |
Detach the 5 clips and remove the No. 2 instrument panel finish panel cushion.
| 3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION |
- HINT:
- Use the same procedure described for the No. 2 instrument panel finish panel cushion.
| 4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end LH.
| 5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end RH.
| 6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH |
w/o Seat Heater System:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
Disconnect the connector.
w/o CRAWL:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
Disconnect each connector.
w/ CRAWL:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
| 7. REMOVE REFRESHING SEAT SWITCH (for Manual Transmission) |
Detach the 2 claws and remove the refreshing seat switch.

- HINT:
- Use the same procedure to remove the refreshing seat switch on the other side.
| 8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) |
![]() ![]() |
Move the shifting hole cover downward.
Text in Illustration *1
Shifting Hole Cover
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 9. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) |
![]() ![]() |
Put protective tape around the console panel.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 8 clips and 2 claws.
Disconnect each connector and remove the console panel.
| 10. REMOVE REFRESHING SEAT SWITCH (for Automatic Transmission) |
Disconnect the 2 connectors.

Detach the 4 claws and remove the 2 refreshing seat switches.






