2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT INJECTION PUMP

  1. Inspect the engine speed sensor.

    1. A223863E01
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (NE-) - 2 (NE+)
      20°C (68°F)
      205 to 255 Ω

      If the result is not as specified, replace the injection pump assembly.

  1. Inspect the spill control valve.

    1. A223864E01
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (SPV-) - 2 (SPV+)
      20°C (68°F)
      1 to 2 Ω

      If the result is not as specified, replace the injection pump assembly.

  1. Inspect the fuel temperature sensor.

    1. A226816E01
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (E2) - 2 (THF)
      20°C (68°F)
      2.21 to 2.69 kΩ

      NOTICE:
      When checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor.

      If the result is not as specified, replace the injection pump assembly.


INSPECT TIMING CONTROL VALVE

  1. Inspect the timing control valve.

    1. A223865E01
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (+B) - 2 (TCV)
      20°C (68°F)
      10 to 14 Ω

      If the result is not as specified, replace the timing control valve.

  1. Inspect the timing control valve operation.

    NOTICE:
    1. Do not apply voltage for more than 30 seconds to avoid burning out the timing control valve solenoid.
    2. When performing this step, wait until the solenoid coils become cool enough that the solenoid can be touched by hand.

  1. Connect the positive (+) lead of the battery to the timing control valve +B terminal.

  1. Connect the negative (-) lead of the battery to the timing control valve TCV terminal.

  1. Check that the solenoid makes a "click" sound.
    If the result is not as specified, replace the timing control valve.


INSPECT INJECTION PUMP DELIVERY VALVE SUB-ASSEMBLY

B001267E01

NOTICE:
Do not touch the sliding surface of the delivery valves.

  1. Pull up the valve and release it. Check that it sinks smoothly into the valve seat. If the operation is not as specified, replace the valve and valve seat as a set.

    HINT:
    Before using a new valve set, wash off the rust prevention compound with diesel fuel. Then rewash with diesel fuel and perform the above test.

← DISASSEMBLY (from Aug 2013)REASSEMBLY (from Aug 2013) →