2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the RH side.


1. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).


2. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

B241192E01
  1. Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the handle.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE FRONT SEAT CUSHION SHIELD RH

B241194
  1. Remove the screw.

  1. Using a moulding remover, detach the 5 claws and 2 clips.

  1. Detach the cable clamp and remove the cushion shield.


4. REMOVE FRONT SEAT INNER CUSHION SHIELD RH

B241195
  1. Using a moulding remover, detach the 5 claws and remove the cushion shield.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH
  1. for Manual Seat, Power Seat 4 Way Seat Type:
    Disconnect the 2 connectors and detach the 3 clamps.

  1. for Power Seat 8 Way Seat Type:
    Disconnect the 2 connectors and detach the 6 clamps.

  1. Remove the nut and front seat inner belt assembly RH.


6. REMOVE SEAT CUSHION COVER WITH PAD

  1. B241196
    Remove the rubber band from the seat cushion spring.

  1. B242236
    Disconnect the seat heater connector and detach the wire harness clamp.

  1. B242244E01
    w/ Front Seat Side Airbag:

    1. Detach the fastening tape and open the cover.

      Text in Illustration 
      *1
      Fastening Tape

    2. Disconnect the airbag wire harness.

  1. B241202
    Using a moulding remover, remove the clip.

  1. B241200
    Detach the hook.

  1. B239243
    Disconnect the seat heater connector and detach the 3 wire harness clamps.

  1. Detach the hooks.

    B239180

  1. B239181
    Detach the claw and disconnect the connector.

  1. Remove the seat cushion cover with pad.


7. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

B239182
  1. Remove the hog rings and seat cushion cover from the seat cushion pad.


8. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH

B239184E01
  1. Cut off the tack pins and remove the front seat cushion heater from the front seat cushion cover.

    Text in Illustration 
    *1
    Tack Pin

← COMPONENTS (from Aug 2014)REMOVAL (from Aug 2014) →