REMOVAL
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the RH side.
| 1.
REMOVE FRONT SEAT ASSEMBLY |
 |
Remove the front seat assembly (Click here).
| 2.
REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
|
 |
Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the handle.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective Tape
|
| 3.
REMOVE FRONT SEAT CUSHION SHIELD RH
|
 |
Remove the screw.
Using a moulding remover, detach the 5 claws and 2 clips.
Detach the cable clamp and remove the cushion shield.
| 4.
REMOVE FRONT SEAT INNER CUSHION SHIELD RH
|
 |
Using a moulding remover, detach the 5 claws and remove the cushion shield.
| 5.
REMOVE FRONT SEAT INNER BELT ASSEMBLY RH
|
 |
for Manual Seat, Power Seat 4 Way Seat Type:
Disconnect the 2 connectors and detach the 3 clamps.
for Power Seat 8 Way Seat Type:
Disconnect the 2 connectors and detach the 6 clamps.
Remove the nut and front seat inner belt assembly RH.
Remove the front seat belt anchor plate.
| 6.
REMOVE SEAT CUSHION COVER WITH PAD |
 |
- Remove the rubber band from the seat cushion spring.
- Disconnect the seat heater connector and detach the wire harness clamp.
- w/ Front Seat Side Airbag:
Detach the fastening tape and open the cover.
Text in Illustration
*1
|
Fastening Tape
|
Disconnect the airbag wire harness.
- Using a moulding remover, remove the clip.
- Detach the hook.
- Disconnect the seat heater connector and detach the 3 wire harness clamps.
Detach the hooks.


- Detach the claw and disconnect the connector.
Remove the seat cushion cover with pad.
| 7.
REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
|
 |
Remove the hog rings and seat cushion cover from the seat cushion pad.
| 8.
REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH |
 |
Cut off the tack pins and remove the front seat cushion heater from the front seat cushion cover.
Text in Illustration
*1
|
Tack Pin
|