PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Result of "How to proceed with Troubleshooting" is "Open in CAN Main Wire" |
Open in CAN Main Wire |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines" |
Short in CAN Bus Lines |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line" |
Short to B+ in CAN Bus Line |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line" |
Short to GND in CAN Bus Line |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line" |
Open in One Side of CAN Branch Line |
Click here
|
- HINT:
- Refer to How to Proceed with Troubleshooting for the CAN V1 Bus Check procedure.
| Symptom |
Suspected Area |
See page |
| "Skid Control (ABS/VSC/TRAC)" is not displayed on the intelligent tester*1 |
Brake Actuator (Skid Control ECU) Communication Stop Mode |
Click here
|
| "Skid Control (ABS/VSC/TRAC)" is not displayed on the intelligent tester*2 |
Skid Control ECU Communication Stop Mode |
Click here
|
| "Air Conditioning Amplifier" is not displayed on the intelligent tester |
Air Conditioning Amplifier Communication Stop Mode |
Click here
|
| "PPS" is not displayed on the intelligent tester*3 |
Power Steering ECU Communication Stop Mode |
Click here
|
| "CAN Gateway1" is not displayed on the intelligent tester*4 |
Gateway ECU Communication Stop Mode |
Click here
|
| "Spiral cable (Steering Angle Sensor)" is not displayed on the intelligent tester*2 |
Steering Angle Sensor Communication Stop Mode |
Click here
|
| "Yaw Rate Sensor" is not displayed on the intelligent tester |
Yaw Rate Sensor Communication Stop Mode |
Click here
|
| "ECM (Engine)" is not displayed on the intelligent tester*3 |
ECM Communication Stop Mode |
Click here
|
| "Main Body" is not displayed on the intelligent tester |
Main Body ECU Communication Stop Mode |
Click here
|
| "Combination Meter" is not displayed on the intelligent tester |
Combination Meter ECU Communication Stop Mode |
Click here
|
| "Airbag" is not displayed on the intelligent tester |
Center Airbag Sensor Communication Stop Mode |
Click here
|
| "Four Wheel Drive Control" is not displayed on the intelligent tester |
4WD Control ECU Communication Stop Mode |
Click here
|
| "Display and Navigation (AVN1)" is not displayed on the intelligent tester*5 |
Audio Receiver Assembly Communication Stop Mode |
Click here
|
- *1: w/o Vehicle Stability Control System
- *2: w/ Vehicle Stability Control System (for Hydraulic Brake Booster)
- *3: for 1KD-FTV
- *4: w/ TOYOTA Parking Assist-sensor System (for 4 Sensor Type)
- *5: w/ Audio and Visual System (for Radio and Display Type)