2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE MAP LIGHT ASSEMBLY

  1. E198057
    Detach the 4 clips.

  1. Disconnect the connector and remove the map light.


2. REMOVE THEFT WARNING RADAR SENSOR
  1. Disconnect the connector.

  1. B238875
    Remove all the tape and the 2 screws.

  1. Detach the clamp and disconnect the central part of the theft warning radar sensor.

  1. B238881
    Using a thin-bladed screwdriver, push the bezel down lightly.

    HINT:
    1. Perform the same procedure on the other side.
    2. Tape the screwdriver tip before use.

  1. B238882
    Insert the thin-bladed screwdriver into the cutout portion of the bezel and remove the bezel from the map light.

    HINT:
    1. Perform the same procedure on the other side.
    2. Tape the screwdriver tip before use.

  1. B238880
    Disconnect the 2 connectors.

  1. B238883
    Remove the 2 screws and theft warning radar sensor.

    HINT:
    Perform the same procedure on the other side.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →