2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Stereo Component Amplifier Power Source Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit provides power to the stereo component amplifier assembly.

WIRING DIAGRAM

E286345E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND)

  1. E286347E01
    Disconnect the stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H64-2 (GND) - Body ground
    Always
    Below 1 Ω
    H64-6 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H64-1 (+B) - H64-2 (GND)
    Always
    11 to 14 V
    H64-3 (+B2) - H64-2 (GND)
    Always
    11 to 14 V
    H63-12 (ACC) - H64-2 (GND)
    Engine switch on (ACC)
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Stereo Component Amplifier Assembly)


NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter (from Aug 2014)Stereo Component Amplifier Power Source Circuit (from Aug 2014) →