2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL TELEPHONE ANTENNA CORD SUB-ASSEMBLY
  1. Connect the connector to install the telephone antenna cord sub-assembly.


2. INSTALL NAVIGATION ECU

  1. B359357
    Insert the navigation ECU as shown in the illustration.

  1. Install the navigation ECU with the 4 bolts.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Attach the clamp.

  1. Connect the connector.


3. INSTALL NO. 1 NAVIGATION WIRE
  1. Connect each connector to install the No. 1 navigation wire.


4. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY
  1. Connect each connector.

  1. B358816
    Insert the radio and display receiver assembly and attach the 7 clips on the backside of the radio and display receiver assembly.

    NOTICE:
    When inserting the receiver, do not press the knobs on it.

  1. Install the radio and display receiver assembly with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


5. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
  1. Connect the connector.

  1. Attach the 4 clips to install the integration control and panel assembly.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
(Click here)
← INSTALLATION (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →