C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.- HINT:
- This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1ABB |
A beam axis inspection has not been performed. |
Blind spot monitor sensor LH |
INSPECTION PROCEDURE
| 1. PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION) |
Change the blind spot monitor sensor LH to Test Mode using the GTS.
- HINT:
- Refer to Blind Spot Monitor Beam Axis Inspection (Click here).
| NEXT | ||
| ||
