2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC Code
DTC Detection Condition
Trouble Area
C1ABB
A beam axis inspection has not been performed.
Blind spot monitor sensor LH

INSPECTION PROCEDURE


1. PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)
  1. Change the blind spot monitor sensor LH to Test Mode using the GTS.

    HINT:
    Refer to Blind Spot Monitor Beam Axis Inspection (Click here).


NEXT

END


← C1AB8 Destination Information Undefined (from Aug 2014)C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (from Aug 2014) →