C1A47 Steering Angle Sensor
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The blind spot monitor sensor receives steering angle signals from the spiral cable sub-assembly via CAN communication.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1A47 |
A fail flag is transmitted from the steering sensor |
|
INSPECTION PROCEDURE
- NOTICE:
- When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.
| 1. CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
| 2. REPLACE SPIRAL CABLE SUB-ASSEMBLY |
Replace the spiral cable sub-assembly with a new or normally functioning one (Click here).
| NEXT | |
| 3. CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
Result Result
Proceed to
No DTC is output
A
DTC is output from the blind spot monitor sensor LH (master)
B
DTC is output from the blind spot monitor sensor RH (slave)
C
|
|
||||
|
|
||||
| A | ||
| ||
