2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1A47 Steering Angle Sensor

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the spiral cable sub-assembly via CAN communication.
DTC Code
DTC Detection Condition
Trouble Area
C1A47
A fail flag is transmitted from the steering sensor
  1. Spiral cable sub-assembly
  2. Blind spot monitor sensor LH
  3. Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. REPLACE SPIRAL CABLE SUB-ASSEMBLY
  1. Replace the spiral cable sub-assembly with a new or normally functioning one (Click here).


NEXT


3. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor LH (master)
    B
    DTC is output from the blind spot monitor sensor RH (slave)
    C



B
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
A

END (SPIRAL CABLE SUB-ASSEMBLY IS DEFECTIVE)


← C1A47 Steering Angle Sensor (Aug 2013 – Jul 2014)C1AB0 Short to +B in Outer Mirror Indicator(Master) (Aug 2013 – Jul 2014) →