2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1691 Back Camera Initialization Incomplete

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the navigation receiver assembly judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).
DTC Code
DTC Detection Condition
Trouble Area
C1691
Back camera initial setting has not been memorized
  1. Rear television camera optical axis adjustment
  2. Navigation receiver assembly

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).


1. ADJUST SETTINGS (CAMERA POSITION SETTING)
  1. Perform the following procedure depending on the memory conditions to register the vehicle information into the navigation receiver assembly.

    1. Refer to rear television camera optical axis adjustment (Click here).


NEXT


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1691 is not output.

    HINT:
    1. If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.
    2. If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the navigation receiver assembly.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END (ADJUST SETTINGS ARE DEFECTIVE)


← C1691 Back Camera Initialization Incomplete (Aug 2013 – Jul 2014)C1694 Steering Angle Initialization Incomplete (Aug 2013 – Jul 2014) →