2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1AB2 Short to GND in Outer Mirror Indicator(Master)

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects a ground short in the blind spot monitor indicator LH.
DTC Code
DTC Detection Condition
Trouble Area
C1AB2
With the blind spot monitor main switch assembly (multi-function switch) on, the voltage output from the blind spot monitor sensor to the indicator is low for a certain amount of time.
  1. Harness or connector
  2. Outer rear view mirror assembly LH
  3. Outer rear view mirror sub-assembly LH
  4. Blind spot monitor sensor LH

WIRING DIAGRAM

E221720E12

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY LH - BLIND SPOT MONITOR SENSOR LH)
  1. Disconnect the K2 outer rear view mirror assembly LH connector.

  1. Disconnect the R42 blind spot monitor sensor LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K2-2 (BSL+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH)
  1. Disconnect the R42 blind spot monitor sensor LH connector.

  1. Disconnect the outer rear view mirror sub-assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R42-4 (OMIL) - Body ground
    Always
    10 kΩ or higher



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK


4. CHECK OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH
  1. Replace the outer rear view mirror sub-assembly LH with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Check for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
OK

END (OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH IS DEFECTIVE)


← C1AB1 Short to +B in Outer Mirror Indicator(Slave) (from Aug 2014)C1AB2 Short to GND in Outer Mirror Indicator(Master) (from Aug 2014) →