2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1AB4 Open in Outer Mirror Indicator(Master)

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an open in the blind spot monitor indicator LH.
DTC Code
DTC Detection Condition
Trouble Area
C1AB4
With the blind spot monitor main switch assembly (multi-function switch) on, the current flowing to the indicator is below a specified value when indicator operation voltage is sent to the indicator.
  1. Harness or connector
  2. Outer rear view mirror sub-assembly LH
  3. Outer rear view mirror assembly LH
  4. Blind spot monitor sensor LH

WIRING DIAGRAM

E221720E12

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY LH - BLIND SPOT MONITOR SENSOR LH AND BODY GROUND)
  1. Disconnect the R42 blind spot monitor sensor LH connector.

  1. Disconnect the K2 outer rear view mirror assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R42-4 (OMIL) - K2-2 (BSL+)
    Always
    Below 1 Ω
    K2-2 (BSL+) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH
  1. Replace the outer rear view mirror sub-assembly LH with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 4
OK

END (OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH IS DEFECTIVE)

4. CHECK OUTER REAR VIEW MIRROR ASSEMBLY LH
  1. Replace the outer rear view mirror assembly LH (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
OK

END (OUTER REAR VIEW MIRROR ASSEMBLY LH IS DEFECTIVE)


← C1AB4 Open in Outer Mirror Indicator(Master) (Aug 2013 – Jul 2014)C1AB5 Open in Outer Mirror Indicator(Slave) (Aug 2013 – Jul 2014) →