C1AB5 Open in Outer Mirror Indicator(Slave)
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH detects an open in the blind spot monitor indicator RH.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1AB5 |
With the blind spot monitor main switch assembly (multi-function switch) on, the current flowing to the indicator is below a specified value when indicator operation voltage is sent to the indicator. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.
| 1. CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again (Click here).
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY RH - BLIND SPOT MONITOR SENSOR RH AND BODY GROUND) |
Disconnect the R43 blind spot monitor sensor RH connector.
Disconnect the J3 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R43-4 (OMIR) - J3-2 (BSR+)
Always
Below 1 Ω
J3-2 (BSR+) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH |
Replace the outer rear view mirror sub-assembly RH with a new or normally functioning one (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again (Click here).
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
| 4. CHECK OUTER REAR VIEW MIRROR ASSEMBLY RH |
Replace the outer rear view mirror assembly RH with a new or normally functioning one (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again (Click here).
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
